24-Port 10/100Mbps PoE Web Smart Ethernet Switch

24-Port 10/100Mbps PoE Web Smart Ethernet Switch

 

Cost-effective Edge Network Connection Solution To provide enhanced network management with cost saving benefit to customers, PLANET releases the new version of the FNSW-2400PS, the Layer 2 Web Smart Switch with PoE injector function. The FNSW-2400PS is equipped with 24 Fast Ethernet ports integrating with PoE injector function. With 125Watts PoE power budget, it provides a compact, affordable, safe and reliable power solution for small to medium enterprises.

 

IEEE 802.3af Power over Ethernet Support

The PoE in-line power following the IEEE 802.3af standard makes the FNSW-2400PS able to deliver power to 24 PoE compliant devices at the distance up to 100 meters through the 4-pair Cat 5/5e UTP wire. It optimizes the installation and safe power management of network devices such as wireless access points (AP), Voice over IP (VoIP) phones and IP Surveillance cameras.With more efficient switching power supply, the efficiency of the FNSW-2400PS would be much better than four linear power adapters in a long run and bring customers the key benefit – energy saving.

 

Easy Cabling Installation

The Power over Ethernet technology enables the Ethernet wire to carry both data and power. With data and power over Ethernet from one unit, the FNSW-2400PS shall reduce cable installation and eliminate the need for extension cords or dedicated electrical outlets on the wall, ceiling or any unreachable place. In all, it lowers the installation costs and simplifies the deployment effort.

 

Friendly Web-Based Management

For efficient management, the FNSW-2400PS is equipped with remote Web interface. It can be programmed for advanced switch management functions such as port configuration, VLAN, Rapid Spanning Tree Protocol (RSTP), IGMP Snooping, port trunk, QoS, bandwidth control, and MAC address / TCP & UDP filter. The FNSW-2400PS provides Port-Based / IEEE 802.1Q / MTU VLAN (port based / IEEE 802.1Q VLAN including overlapping). The VLAN groups allowed on the FNSW-2400PS will be maximally up to 24 for port based or up to 32 for IEEE 802.1Q VLAN groups. On the other hand, the MTU VLAN divides port 1 to port 24 as separate LAN group. Via supporting port trunking, the FNSW-2400PS allows the operation of a high-speed trunk combining multiple ports. The FNSW-2400PS also provides two groups of up to 4-Port 10/ 100Base-TX trunk support with up to 800Mbps bandwidth per trunk group.

 

Physical Port

24-Port 10/100Mbps Fast Ethernet ports with PoE Injector

Reset button for system management

 

Power over Ethernet

Complies with IEEE 802.3af Power over Ethernet Mid-Span PSE

Up to 24 IEEE 802.3af devices powered

Supports PoE Power up to 15.4 Watts for each 802.3af PoE port

Auto detect powered device (PD)

Circuit protection prevents power interference between ports

Remote power feeding up to 100m

 

Layer 2 Features

Auto-MDI / MDI-X detection on each RJ-45 port

Prevents packet loss with back pressure (Half-Duplex) and IEEE 802.3x PAUSE Frame Flow control (Full-Duplex)

Supports VLAN:

–IEEE 802.1Q Tag-Based VLAN

–Port-Based VLAN

–MTU VLAN (Multi-Tenant Unit VLAN)

Supports Link Aggregation

–up to 2 trunk groups

–up to 4 Fast Ethernet ports per trunk group

–IEEE 802.3ad LACP (Link Aggregation Control Protocol)

Supports Spanning Tree Protocol

–STP, IEEE 802.1D (Classic Spanning Tree Protocol)

–RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)

–Loopback Detection

Port Mirroring to monitor the incoming or outgoing traffic on a particular port

 

Quality of Service

2 priority queues on all switch ports

Traffic classification:

–Port-Based priority

–IEEE 802.1p based priority

–IP TOS / DSCP based priority

–TCP / UDP Port-Based QoS

Strict priority and Weighted Round Robin (WRR) CoS policies

In/Out rate limit control on each port

Broadcast Storm Control support

 

Multicast

Supports IGMP Snooping v1 and v2

 

Security

MAC address filter

TCP & UDP filter on each port

Management idle time security

 

Management

Remote Web interface for Switch management and setup

Supports SNMP v1

Supports DHCP Option 82 and DHCP Relay

Firmware upgrade through Web interface

Configuration upload / download through Web interfaceReset button for system reboot or reset to factory default

 

 

Model

FNSW-2400PS

Ports

24 10/100Base-TX RJ-45 Auto-MDI/MDI-X interfaces

Switch Processing Scheme

Store-and-Forward

Throughput (packet per second)

3.57Mpps@64Bytes

Switch Fabric

4.8Gbps

Address Table

8K entries

Share Data Buffer

1.75Mb embedded memory for packet buffers

Flow Control

Back pressure for Half Duplex, IEEE 802.3x Pause Frame for Full Duplex

Dimension (W x D x H)

445 x 207 x 45 mm (1U height)

Weight

2.55kg

Power Requirement

100~240V AC, 50-60 Hz, 2A

Power Consumption / Dissipation

Max.135 Watts / 460 BTU

System Configuration

Web interface, SNMP v1

Port Configuration

Port Speed Duplex mode selection

Port Disable / Enable

Bandwidth Control

Yes

Broadcast Storm Control

Yes

Port Statistics

Display each port’s detail Ethernet traffic counter information

VLAN

24 port-based VLAN groups / 32 IEEE 802.1Q VLAN groups / MTU VLAN

Spanning Tree Protocol

STP, IEEE 802.1D (Spanning Tree Protocol)

RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)

Port Trunking

2 groups of 4-Port 10/ 100Base-TX trunk support, up to 800Mbps bandwidth per trunk group

Port Mirroring

Port mirroring allows monitoring of the traffic across any port in real time

QoS

Allows to assign low / high priority on each port

First-In-First-Out, All-High-before-Low, Weight-Round-Robin QoS policy

MAC Address / TCP & UDP Filter

Yes

IGMP Snooping v1 / v2

Allows to Disable or Enable

PoE Standard

IEEE 802.3af Power over Ethernet / PSE

PoE Power Supply Type

Mid-Span

PoE Power output

Per Port 48V DC, 350mA . Max. 15.4Watts

Power Pin Assignment

4/5(-), 7/8(+)

PoE Power Budget

125Watts

Regulation Compliance

FCC Part 15 Class A, CE

Standards Compliance

IEEE 802.3 Ethernet

IEEE 802.3u Fast Ethernet

IEEE 802.3af Power over Ethernet (15.4Watts)

IEEE 802.3x Full-Duplex flow control

IEEE 802.1Q VLAN

IEEE 802.1p QoS

IEEE 802.1D Spanning Tree Protocol

IEEE 802.1w Rapid Spanning Tree Protocol

Temperature

Operating: 0~50 Degree C

Storage: -10~70 Degree C

Humidity

Operating: 5~95%

Storage: 5~95% (Non-condensing)